Appliance Handover; Specification; Dimensions - Cir 150-1 I - Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi

INSTALLATION

APPLIANCE HANDOvER

14. Remove the heat lamp retainer clips both ends of lamps.
One clip at each end of heater
»
Two clips in the center of heater:
»
10. Appliance handover
Explain the functions of the appliance to the user. Draw special attention to the safety information. Hand the operating and installation
instructions to the user.

11. Specification

11.1 Dimensions - CIR 150-1 I

inches
(mm)
WWW.STIEBEL-ELTRON-USA.COM
1 9/16˝
(40)
#10
1 9/16˝
15 9/16˝
(40)
(395)
15. The heat lamp is very fragile - handle and assemble with great
care!
Carefully slide old heat lamp out of heater through rectangular
»
slot in end of reflector.
CAREFULLY install new heat lamp and clip in place.
»
Reverse steps above to reassemble the heater.
»
Take particular care not to damage the lamp at Step 14 and
»
Step 13:
Rear
Top
Front
SUNWARMTH CIR INFRARED HEATER|
™
1
(
19