Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 13

INSTALLATION
INSTALLATION
2. Remove end cover at both ends of heater. Six (6) Phillips screws
hold the end cover in place. Remove the screws to secure storage:
3. Slide out the face plate at each end of heater to expose both
ends of the heat lamp:
4. Turn heater face down, and slide the center cover plate and
the heater mounting bracket out of the heater:
WWW.STIEBEL-ELTRON-USA.COM
5. Disconnect electrical supply cord spade connectors from
terminals:
6. Disconnect ground wire (electrical supply cord) from the heater
body by removing the anchor screw from the eye of the ground
terminal:
7. Slide power cord retainer plate from heater body:
SUNWARMTH CIR INFRARED HEATER|
™
13