Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 14

INSTALLATION
INSTALLATION
8. Turn heater face up. Each end of the lamp has a rectangular
retainer block. Remove the stainless steel clips that secure the
retainer blocks at each end of the lamp:
9. Pull the lamp wires up and out from the heater body at each
end of the lamp:
10. Slide the lamp out through the reflector end plate. Properly
and safely dispose of lamp:
11. The heat lamp is fragile - handle with care! Wear gloves. Do
not touch lamp with bare fingers! Oils from your skin will damage
the lamp.
Install the new replacement lamp
»
Reassemble heater in reverse order of steps above.
»
9.8.2 Heat lamp replacement - CIR 150-1 O and CIR 200-2 O
1. Compress the width of the protective grill to retract the wire
tabs from under one edge of the heater body.
» Rotate the lose edge of the grill up and away from
heater body.
14 |SUNWARMTH ™ CIR INFRARED HEATER
» Pull the grill away from heater to remove from other edge
of heater body - place safety grill in a secure storage
container:
2. Remove connection box end cover. Six (6) Phillips screws hold
the end cover in place. Remove the screws and keep in a secure
storage area:
3. Remove connection box end cover. Six (6) Phillips screws hold
the end cover in place. Remove the screws to secure storage:
WWW.STIEBEL-ELTRON-USA.COM