Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 9

INSTALLATION
INSTALLATION
4. Models CIR 150-1 I and CIR 150-1 O: If at all possible, locate
the mounting bracket so that the electrical cord (8 ft [2.4 m]) can
be plugged into an electrical outlet (grounded 120 V) without
stretching the electrical cord taut. See important notice (section
9.3, pg. 7) regarding the use of an extension cord.
5. Never allow an electrical cord to pass in front of the heater or
to come into contact with any hot surface of the heater.
6. The mounting bracket fastens to the structure using field
supplied bolts or lag screws through two holes in one side of
the bracket. The heater bracket fastens to the mounting bracket
through the outermost hole on the other leg of the mounting
bracket using the bolt, lock washer and nut supplied.
7. Fasten the mounting bracket plumb and level so that the heater
is oriented horizontally on the long axis.
8. Ensure that the mounting bracket is firmly fastened to the
structure with bolts or lag screws (field supplied) of sufficient
strength and integrity to support the weight and prevent movement
of the heater. It is recommended to fasten the mounting bracket
to a structural member (wall stud, etc.).
Mounting Bracket for CIR 150-1 I and CIR 150-1 O
4 5/16˝
(110)
1 5/8˝
(42)
1 1/4˝
(32)
Ø8.5
WWW.STIEBEL-ELTRON-USA.COM
3 1/8˝ 1/2˝
(80) (13)
3-Ø13
8˝
(203)
2 1/2˝
(63)
Mounting Bracket for CIR 200-2 O
2 15/16˝
(75)
1 5/8˝
(42)
1 1/4˝
(32)
M8
3 1/8˝
(80)
6 5/8˝
(168)
Ø8.5
SUNWARMTH CIR INFRARED HEATER|
™
1/2˝
(13)
3-Ø13
M8
9