Stiebel Eltron SunWarmth CIR 150-1 I Mode D'emploi page 17

INSTALLATION
INSTALLATION
2. Remove end plate from heater: 6 Phillips screws fasten the
heater body end plate in place:
3. Remove 4 Phillips screws that hold connection box to heater:
4. Remove the 2 Phillips screws that fasten the electrical
connection box front face plate in place:
WWW.STIEBEL-ELTRON-USA.COM
5. Slide the connection box front face plate out from the electrical
connection box:
6. Slide power cord retainer plate from electrical connection box
(top surface):
7. Loosen screws in terminal block to remove wires as required:
RED wires connect to Lamp #1 (closer to connection box)
»
BLUE wires connect to Lamp #2 (further end from box)
»
Do not disconnect power supply wires
»
Loosen the threaded clamping collar on the Liquid Tight
»
Connector located behind the wiring terminal
Pull wires out through the Liquid Tight Connector and top of
»
electrical connection box:
SUNWARMTH
Electrical
connection
box
CIR INFRARED HEATER|
™
17