Mounting The Flat Screen; Flat Screens With Flat Back; Flat Screens With Arched Back - Goobay TV EasyFix XL2 Mode D'emploi

User's Manual
A
Fig. 5: Wall mounting
1. Before drilling, attend to live cables or other lines lying behind plaster, and
do not damage them.
2. Use a spirit level to mark the drill holes on the wall.
3. Drill the holes with a 10 mm concrete drill 60 mm deep.
Make sure that you use 2 attachment points per side.
4. Plug a concrete anchor (W-B) in each drilling hole.
5. Mount the wall mount (A) by using the wall screws (W-A) and washers
(W-C).
4.3 Mounting the flat screen
Risk of injury by tripping and falling
>> Place, transport and install product, parts
and acceories in a safe way.
Risk of material damage by improper
procedure
>> Only use moderate force when tightening
the screws in order to avoid damaging
threads.
>> NEVER set the screen on the front during
installation!
>> Do not damage the flat screen by too
long screws.
Tab. 16: Mounting the flat screen
4.3.1 F lat screens with flat back
20
67820_manual_DACH_V3.indd 20-21
A
Fig. 6:

Flat screens with flat back

1. L ean the flat screen vertically on a soft, large surface or a wall and protect it
of scratches and overturning.
2. Install one adapter bracket (B) on each side with the washers (M-F) and the
fitting screws, matching to your flat screen on the top and bottom side as
shown.
Make sure that the slots are located on the flat screens top.

4.3.2 Flat screens with arched back

Fig. 7: Flat screens with arched back
1. Apart from the following working step - proceed like shown in chapter 4.3.1.
2. Mount the fitting TV spacers (M-G) and/or ( M-H) between adapter bracket
(B) and flat screen like shown.
B
21
30.05.2018 11:43:44