Multi-Channel Operation - Sennheiser EM 3731 Notice D'emploi

Scan reset
Channel list
Scan new
Scan reset
Bank 1 2 3
Free 43 40 42
Bank 4 5 6 U
Free 32 31 33 60
save
DEV 790.800
M
H
z
sync
03.03
BANK
AF COM
esc
CH
Releasing channels that are used or subject to interference
After the scan, the channels that are occupied or subject to interference
are marked with a warning triangle and the text
"Tune" menu. Via the
The last scan result is deleted.
Turn the jog dial
Press the jog dial
The number of free channels is reset to the maximum for all frequency
banks.
Turn the jog dial
Press the save button
The selected frequency bank is automatically called up in the "B.Ch"
digital audio
processing
menu.
sync

Multi-channel operation

Combined with Sennheiser 3000 and 5000 series transmitters, the
receivers can form transmission links that are suitable for multi-channel
operation.
CAUTION! Risk of reception interference!
If – within the receiver's frequency range – transmitters
transmit on channels from different frequency banks, reception
can be subject to interference and inter-modulation. Only the
factory-preset frequencies within the frequency banks "1" to
"6" are interference and inter-modulation free.
Set all transmitters of a multi-channel system to different
channels within the same frequency bank.
Before putting the transmission links into operation, we recommend that
you perform a scan in order to find a frequency bank with a sufficient
number of free channels:
Switch all transmitters off.
Use a receiver to scan all frequency banks for free channels (see
"Scanning the frequency banks for interference-free channels" on
page 33).
Select a frequency bank with a sufficient number of free channels (see
"Selecting a frequency bank and a channel" on page 28).
Set each transmitter/receiver pair in your multi-channel system to a
different free channel within this frequency bank.
"Scan reset" menu, you can unmark these channels.
7
until the arrow points to
7
.
7
to select a frequency bank.
8
.
The operating menu
"Freq. occupied" in the
"Scan reset".
35