Sennheiser EM 3731 Notice D'emploi page 84

The operating menu
Display
790.800
NAME
save
790.800
DEV
M
H
z
sync
03.03
BANK AF COM
esc
CH
IP-Addr
192.
168.
0.
0
Auto
save
DEV 790.800
M
H
z
sync
03.03
BANK AF
COM
esc
CH
36
Selecting the status display
Via the "Display" menu, you can select the status display:
Selectable status display
1. "Name"
displays the freely selectable name
2. "Bank/Channel"
displays the frequency bank and the
channel number
3. "Name/Command"
displays the freely selectable name
and the command display
(EM 3732 Command receiver only)
4. "Bank/Channel/Command"
displays the frequency bank, the channel
number and the command display
(EM 3732 Command receiver only)
Change to the setting mode of the "Display" menu.
The current status display starts flashing.
1
Select one of the four status displays by turning the jog dial
Press the save button
The selected status display becomes effective. The display changes to
digital audio
processing
the selection mode of the operating menu.
sync
Changing the IP address
Via the "IP-Addr" menu, you can display and change the receiver's IP
address. The IP address consists of four bytes and each byte consists of up
to three digits (from 0 to 255). The receiver is factory-preset to dynamic
IP addressing ("Auto").
To manually assign an IP address:
Change to the setting mode of the "IP-Addr" menu.
192.
The first byte starts flashing.
049. 049
068 068.
Select a value between 0 and 255 by turning the jog dial
Press the jog dial
byte.
digital audio
processing
Repeat the last two steps to select all four bytes.
sync
After you have selected the complete IP address, press the
8
.
Switch the receiver off and on again (see "Switching the receiver on/
off" on page 19).
The new IP address becomes effective.
790.800
790.800
790.800
790.800
8
.
7
to confirm the first byte and change to the next
Contents of the display
M
H
z
NAME
M
H
z
03.03 BANK
CH
M
H
z
NAME
AF COM
M
H
z
03.03 BANK
AF
COM
CH
7
.
7
.
save button