Daisy Chaining Up To Eight Twin Receivers - Sennheiser EM 3731 Notice D'emploi

Putting the receiver into operation
ANT A
16
Mounting and connecting remote antennas
Use a remote antenna (available as accessories) when the receiver
position is not the best antenna position for optimum reception.
Connect the remote antennas to the BNC sockets
of the receiver using a low-attenuation 50-Ω coaxial cable.
Note:
Ready-made antenna cables from Sennheiser are available as
accessories with length of 1 m, 5 m and 10 m (see "Accessories/spare
parts" on page 43).
If you connect active antennas (e.g. A 3700, AD 3700) or antenna
boosters (e.g. AB 3700), switch the DC supply voltage for external
active antennas and antenna boosters on (see page 30) so that the
N S
LEDs and
antenna boosters, switch the booster supply voltage off so that the
N S
LEDs and
Note:
If the booster supply voltage is switched on (see page 30), it remains
switched on even when the receiver is switched off.
Position antennas in the same room in which the transmission takes
place! Maintain a minimum distance of 1 m between antennas and a
minimum distance of 50 cm between antennas and metal objects
(including reinforced concrete walls)!

Daisy chaining up to eight twin receivers

The twin receivers feature an integrated antenna splitter so that up to
ANT B
eight twin receivers can be daisy chained using the supplied short antenna
daisy chain cables. The label
range.
Connect the two supplied telescopic antennas or two remote antennas
(available as accessories) to the BNC sockets
the first twin receiver.
Use the supplied 50 Ω antenna cables to daisy chain the twin receivers
as shown in the diagram on the left.
Note:
The antenna signals are also daisy chained when a receiver is switched
off. If the booster supply voltage is switched on (see page 28), it
remains switched on even when the receiver is switched off.
light up; if you do not connect active antennas or
do not light up.
V
indicates the daisy chained frequency
O R
and at the rear
O R
and at the rear of