Becker Centronic Timecontrol TC52 Notice De Montage Et D'utilisation page 64

SETTING
Prog2 END POS (time/position programming)
PROG 2 END POS
You will only see this interactive window if a time is set in
PROG2.
1. You have confirmed the menu item PROG1 END POS. PROG2 END POS ap-
pears.
2. You can choose between PROG 2 END POS, PROG 2 INTERM POS and
PROG 2 VENT/TILT using the +/- button.
3. Confirm your selection with OK.
4. The PROG2 END POS function is now set.
5. For details on further programming in the SETTING menu, please continue
reading.
64 - en