Publicité
Les langues disponibles
Les langues disponibles
Connect a normal ½" garden hose (reinforced) of min. 5m. and max. 25m. to the water supply and
turn it on for a short time in order to flush any dirt out of the hose. Now use a quick connector to
connect the hose to the water inlet (see fig. 7).
Attention!
The water temperature may not exceed 40°C.
The pressure of the water supplied may not exceed 0.7 MPA (7 bar).
Only use clean water with this machine. Impurities or aggressive chemicals damage the machine!
Turn the On/Off switch to the 0 - OFF position (see fig. 9).
Check that the specifications of the socket that you wish to use correspond with those on the type
plate of the machine. If this is the case, insert the plug into the socket.
OPERATION
Open the water supply completely.
Unlock the safety lock by pushing the button to the right (see fig. 8).
Now squeeze the trigger for several seconds in order to de-aerate the hose.
Switch the machine on by switching the On/Off button to I – ON (see fig. 9). The motor will start
briefly, but will stop again as long as the trigger is not squeezed.
Now squeeze the trigger – the machine will start.
The automatic start/stop system means that the motor only works when the trigger is
squeezed!
The jet produced by the jet lance can be adjusted from narrow to wide by turning the head of the
lance. Never do this while spraying!
The rotating heaD creates a narrow rotating jet.
The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such as terraces, small
streets, steps, (garden) walls, etc. The cap provides protection from water splashing back. Attention:
the powerful jets can damage softer materials such as paint and wood, etc! (see for assembly
terrace cleaner fig. 13)
TIPS FOR USE
When the water jet leaves the nozzle it causes the handle to recoil. You must therefore ensure that
you are standing in a stable position and have a firm grip. Also ensure that the high pressure of the
water jet does not cause objects to move out of place or fall or fly around and cause damage. Also
select a safe location for yourself!
Keep your work environment clean and tidy.
The high-pressure jet can cause damage to, for example, tyres if you move the jet too close. Always
maintain a minimum distance of 30 cm from the object to be cleaned! Always adjust the distance to
the object to be cleaned (and therefore the pressure) appropriately.
Work from the bottom to the top in the case of vertical surfaces.
Prevent water from splashing onto undesired places.
Do not move the cleaner by pulling the electrical cable. Do not lift the machine up with the cable.
Prevent damage to the cable caused by oil, solvents, sharp edges, etc. Do not cover the machine
during use.
Do not use the machine in an insufficiently ventilated room.
It is forbidden to clean surfaces containing asbestos with high-pressure.
If the machine is not used for longer than 5 minutes it must be switched off.
SWITCHING OFF
Switch the machine off (Button to 0 - OFF).
Close the water supply.
Allow any pressure to escape by squeezing the trigger until no more water comes out of the nozzle.
Close the safety lock on the handle.
Pull the plug out of the socket.
Important: Always point the jet down!
16
Publicité
