stayer SCR315W Instructions D'emploi page 40

4.Connecting the power supply,
cabling, fuses, kind of base for the
plug and grounding requirements
1. The machine shall be connected to an officially
approved electric installation with grounding.
The machine shall be compulsorily be
connected to the officially approved differential
circuit breaker actuated by a maximum current
leakage of 300 mA and a maximum
performance of 50 ms and an officially approved
dedicated magnetothermal switch of 10
Amperes.
2. The machine does not have fuses.
3. The machine's inner and outer cabling is
complete so that no cabling is required for
installation.
4. The machine's plug is of the Schuko hybrid EEC
7/7 type according to IEC/TR 600083.
5. The requirements for the grounding are those of
the officially approved electric installation to
which the machine is connected.
5.Illustrated description of the
functions
1. On/Off switch.
2. Locking button for continuous operation.
3. Machine handle.
4. Trigger for unlocking the upper head position.
5. Machine motor.
6. Pendular guard for the lower cutting table.
7. Fastening system for the fix cutting length
adjustment.
8. Stop guide.
9. Fix cutting length fit system by stopper.
10.Machine base.
11. Holes for clamp fastening.
12.Rubber support leg.
13.Control for adjusting the horizontal angle.
14.Lockable horizontal cutting angle scale.
15.Lower cutting table.
16.Cutting disk.
17.Fastening flange for the cutting disc .
18.Fastening screw for the cutting disc.
19.Fastening washer for the cutting disc.
20.Rear guard of the lower cutting table.
21.Machine carter.
22.Fastening holes for table extension.
ENGLISH
38
23.Fastening hole adjust cutting length adjustment
system.
24.Transversal shaft.
25.Particle exit tube.
26.Adjustment screw for maximum opening of the
head.
27.Adjustment screw for maximum vertical
inclination adjustment (45%) of the head.
28.Locking head screw in respect of the
longitudinal shaft.
29.Longitudinal shaft.
30.Screw for adjusting the perpendicularity of the
head (90º).
31.Screw for adjusting the resting position of the
head.
32.Knob for fixing head in the horizontal resting
position.
33.Vertical angle indicator.
34.Screw for fine adjustment of the cutting
perpendicularity.
35.Vertical angle scale.
36.Horizontal angle indicator.
37.Adjustment screw of the vertical scale.
38.Upper cutting table.
39.Separator knife of the upper table.
40.Butterfly nuts of the fastening screws of the
upper table.
41.Telescopic guides of the cutting disk.
42.Movable guard of the upper table.
43.Front guide of upper table.
44.Cutting depth adjustment stop of the guard of
the upper table.
45.Screws for adjusting the separator knife of the
upper table.
46.Label.
47.Bolt for locking the vertical inclination of the disk.
48.Butterfly nut for locking the telescopic guide.
49.Movable stop for inclined cuts.
50.Autonomous bag for collecting sawdust.
51.Nut for adjusting the stability of the lower table.
52.Hole for safe fastening of the machine.
53.Fastening screws of the upper table.
54.Pusher stick according to regulations.
55.Moving wheels of the pendular guard.
56.Supporting extension for the work piece.
57.Locking button of the supporting extension for
the work piece.
58.Work piece holding clamp.
38