Intended Use Of The Machine; Unpacking And Assembly - stayer SCR315W Instructions D'emploi

1.Intended use of the machine

This electric tool has been designed only and
exclusively for:
1. Working stationarily on a flat and stable surface.
2. Working on hard and soft wooden work pieces.
3. Working on particle board work pieces.
4. Working on fiberboard work pieces.
5. Working on PVC tube work pieces.
6. Making straight-lined cuts lengthwise and
widthwise of the work piece.
7. Making horizontal miter cuts between -50º and
60º
8. Making vertical miter cuts between 90º and 45º.
Refer to the limits of the work piece in chapter 11
below.

2.Unpacking and assembly

Unpacking
1. Open the box cutting the seal.
2. Remove upper cardboard stops.
3. Take the machine out of the box by its center of
gravity, grasping the operator head and the
motor firmly using both hands to balance the
weight. Two persons are needed to take out the
machine.
4. Take out the accessories box.
5. Take out the documentation.
6. Keep the cardboard box, the stops thereof, the
accessories box and the documentation
permanently in a safe inventoried environment
that is easily accessible and known to the user.
Packing
B C D
IMAGES
Operation 1: Secure, fold and fix the operator
head, for this purpose:
1. Move the head horizontally until placing it about
5 cm from the front stop of the guides 41 as
shown in the photograph. To do so,
accommodate the fastening butterfly nut 48 to
move the head 48. Tighten to lock the head
ENGLISH
37
2. Operate the control 13 to put the set of the head
3. Lower the machine's upper head so as to place it
4. Remove the upper shield 42 by removing two
5. Lower the upper table 43 as far as it will go, by
Operation 2: Package the machine.
1. Retrieve the box and its stops.
2. Retrieve the documentation and accessories.
3. Hold the machine firmly by the operator head
4. Place the machine on the 4 circular slits of the
5. Put the documentation on top of the upper table.
6. Put the machine accessories into their
7. Position the upper cardboard stops.
8. Close the box fastening it with a sealing strap.
3.Setting or fastening the tool in a
stable position
1. The workstation where the machine is
2. Put the machine in a stable position on a flat
3. The base of the miter has four holes 11 for
M
37
and lower table into a resting position
horizontally at 45º. Lift 13-A so as to release the
set head and lower table by unlocking the turn
pushing 13-A. Once the machine has been
positioned secure it by lowering the control 13-A.
in a resting position by lowering the handle 3 and
unlocking the descent by means of 4. Once
down, lock the head by means of the bolt 32.
screws.
acting on fastening butterfly nuts 40.
and the motor body. Two persons are needed to
carry out this operation.
base of the box, in accordance with photograph "M"
cardboard box.
implemented must compulsorily be secure.
surface.
fastening the machine tightly to the work bench.
It is strongly recommended to fasten the
machine to the bench by means of the
corresponding screws and nuts.