MC Crypt DJM-300 Notice D'emploi page 28

Connection and Control Elements
(6) Channel faders
The channel faders are for adjusting the level of each channel.
Slide control to the bottom position = minimum channel level
Slide control to the top position = maximum channel level
The channel fader of channels that are not in use should be slid right down. This reduces the possibility
of interference.
(7) TALK button
Press this button to decrease the volume of the remaining channels when making announcements via the
DJ microphone. This makes the announcements better audible without requiring any adjustment of the other
channels' volume.
(8) Beat counter BPM
The two beat counters show the BPM value of the respective channel. This display is used to match the beat
speed for use of the crossfader (9).
(9) Crossfader
Use this slide control for crossfading between CHANNEL 2 and CHANNEL 3.
One channel is faded out with the slide control while the other channel is faded in. With the cross-fader slide
control in the centre position, both channels are reproduced equally.
(10) Level indicator
The level display indicates the level of the audio signal. The indicator should not exceed "0dB", as otherwise
the music signal can be distorted.
The MAIN display refers to the master signal level.
The CUE display refers to the pre-listening signal level (headphone signal).
(11) POWER switch
Use this switch to turn the mixer on or off. The mixer is on in the I position.
When the mixer is turned on, the red LED display next to the POWER switch lights up.
(12) MASTER control
Use this control to set the level at the MASTER output (19).
28