MC Crypt DJM-300 Notice D'emploi page 29

Connection and Control Elements
(13) BALANCE control
This control sets the volume balance between the left and the right channel of the master output.
(14) BOOTH control
This control sets the level at the BOOTH (20) output.
(15) CUE control
This control sets the volume of the headphones.
Turn the control to the "MIN" position before plugging in, unplugging or putting on the
headphones or before switching the mixer on or off. Otherwise, there is risk of damage to your
hearing as a result of excessive volume from the headphone output.
(16) CH1 to CH3 switches
These switches are used to determine what channels are played on the headphone channel for pre-listening.
(17) CUE/MASTER control
This control sets the volume ratio between the pre-listening signal (determined with switches CH1 to CH3)
and master output signal on the headphones channel.
(18) PHONE connection
A stereo headphone can be connected to this 6.3 mm jack socket.
(19) MAIN OUT MASTER connection
This output is intended for connection of the amplifier.
The signal volume is affected by the GAIN (2) controls, the channel faders (6) and the MASTER LEVEL
(12) control.
(20) BOOTH connection
Connection for a second amplifier (e.g. in an adjoining room or for monitor loudspeakers)
The signal volume is affected by the GAIN (2) controls, the channel faders (6) and the BOOTH (14)
control.
29