MC Crypt DJM-300 Notice D'emploi page 30

Connection and Control Elements
(21) TAPE connection
This output is intended for connection of a recording device, such as a DAT recorder, tape recorder or CD
recorder, to record the signal from the mixer.
This output is not influenced by the MASTER control (12).
(22) GND earthing screws
To prevent humming distortion, an earth connection can be established between the mixer and the earth line
of the record player (usually black cable with clamp-type socket) via these screw clamps.
(23) INPUT 1 connection
A record player or device with a line level (e.g. CD player) can be connected to this connection. The input
sensitivity is switched with the PHONO/LINE (28) switch.
(24) Fuse holder
The mains fuse is installed here. The "Maintenance" section of these instructions includes instructions on how
to change the fuse.
(25) Mains connection
Plug in the mains cable here.
(26) LINE sockets
Connect your LINE devices to these inputs. INPUT 2 is intended for CHANNEL 2, INPUT 3 for
CHANNEL 3.
These inputs are exclusively suitable for LINE devices like CD players. Never connect record
players here.
(27) PHONO connection
Connect your record players to these inputs. INPUT 2 is intended for CHANNEL 2, INPUT 3 for
CHANNEL 3.
These inputs are only suitable for record players with magnetic sound pick-up systems.. Never
connect any devices with line outputs here, such as CD players.
(28) PHONO/LINE switch
This switch determines the device type connected to the connection INPUT 1.
PHONO position: The connection is set for record players.
LINE position: The connection is set for line devices like CD players.
30