AERMEC FCL 32 Manuel D'installation page 25

INSTALLATION
ATTENTION: before carrying out any inter-
vention, make sure that the electric power
supply has been disconnected.
ATTENTION: before carrying out any work,
wear the appropriate individual protection
devices.
ATTENTION: The appliance must be installed
in compliance with national regulations on
this subject.
ATTENTION: the electric connections, the
installation of the fan coils and their acces-
sories must only be performed by subjects
with the technical-professional requisites
for enabling and installation, transforma-
tion, extension and maintenance of the
systems and able to check the same for
safety and functionality purposes (in this
manual they will be indicated by the gene-
ric term "staff with specific technical skill").
In particular, for the electric connections,
checks relative to the following are reque-
sted:
- Measurement of the electric plant isolation
resistance.
- Continuity test of the protection wires.
ATTENTION: Install a device, master switch
or electric plug that allows to completely
interrupt the appliance's electric power
supply.
Here find the essential indications for correct
installation of the appliance.
The completion of all operations, according
to specific requirements, is left to the expe-
rience of the installer.
The water, condensate drainage and electrical
circuit ducts must be provided for.
The fan coil must be installed in a position
such to easily allow routine maintenance
SIZE RECOMMENDED INSTALLATION
Module "600"
Installation bracket dimensions
Overall dimensions of the water connections
Installation bracket dimensions
24
IFCLIJ 1805 - 4528500_09
(cleaning the filter) and extraordinary main-
tenance, as well as access to the air vent
valve on the side of the frame (connections
side).
Do not install the unit in rooms where inflam-
mable gases or acid or alkaline substances
are present that can permanently damage
the copper-aluminium heat exchangers or
internal plastic components.
Do not install the unit in workshops or
kitchens, where oil vapours mixed with the
treated can deposit on the heat exchanger
coils, reducing their performance, or on the
internal parts of the unit, thus damaging the
plastic components.
The fan coil must be installed in a position
such that the air can be distributed throu-
ghout the entire room, that there are no
obstacles (curtains or objects) to the passa-
ge of air from the intake grids.
Choose a position in the centre of the room
if possible; the regulation of the air output
allows the air to be distributed optimally in
the room. Generally the best position of the
fins is that that allows the launch of the air
adhering to the ceiling for the coined effect,
during cold functioning. The side section of
the deflectors (Module 600)shows the ope-
ning positions for proper warm functioning
(opening 20°) and cold functioning (opening
10°) of the machine.
For the Module 840 units, it is recommended
to completely open the deflector in heating
mode. In cooling mode, rotate the deflector
to half way.
Depending on the user's requirements, it is
possible to position the louvered fins in the
intermediate of complete closure positions.
Thanks to the special shapes of the louvered
fins the machine can also function with the
deflectors completely closed.
Do not install at height of above three
metres.
The FCL unit is set for connection with fresh
air ducts and for the flow of the treated air
in an adjacent room.
- Module 600 (GLL) 20 ° hot opening;
- Module 600 (GLL) 10 ° cold opening;
- Module 840 (GLL) 25 ° hot opening;
- Form 840 (GLL) 10 ° cold opening;
- Module 600 (GLF) maximum hot opening;
- Module 600 (GLF) maximum cold opening;
Module "840"
Overall dimensions of
the water connections
Installation bracket
dimensions
Installation bracket
dimensions
Condensate
discharge side
Installation bracket
dimensions
Installation bracket
dimensions