AERMEC FCL 32 Manuel D'installation page 19

INDEX
Important information • Maintenance • Packaging
Functions
Use
Description • Versions • Functioning limits
Main components • Component description
Installation of the unit
Connections
Installation and replacement of the filter
Dimensions
Wiring diagrams
IMPORTANT INFORMATION AND MAINTENANCE
ATTENTION: the fan coil is connected to
the power supply and a hydraulic circuit.
Operations performed by persons without
the required technical skills can lead to
personal injury to the operator or damage
to the unit and surrounding environment.
ONLY POWER THE FAN COIL USING 230
VOLT, SINGLE-PHASE VOLTAGE
The fan coil may undergo permanent dam-
age if different electric power supplies are
used.
N E V E R U S E T H E FA N C O I L F O R
APPLICATIONS FOR WHICH IT WAS NOT
DESIGNED
Do not use the fan coil in husbandry appli-
cations (e.g. incubation).
AIR THE ROOM
Periodically air the room in which the fan
coil has been installed; this is particularly
important if the room is occupied by many
people, or if gas appliances or sources of
odours are present.
ADJUST THE TEMPERATURE CORRECTLY
Room temperature should be regulated
to ensure maximum comfort to persons
present, particularly in the case of the
elderly, infants and invalids. Prevent
temperature fluctuations between indoors
and outdoors greater than 7 °C during
summer.
If the temperature is too low in the
s u m m e r, t h e re i s g re ate r e n e rg y
consumption.
DIRECT AIR FLOW CORRECTLY
Air delivered by the fan coil should not
be directed directly at people; even
if air temperature is greater than room
temperature, it can cause a cold sensation
and consequently discomfort.
DO NOT USE WATER THAT IS TOO HOT
When cleaning the fan coil, use cloths or
soft sponges soaked in warm water (no
higher than 40°C). Do not use chemical
products or solvents to clean any part of
PACKAGING
The fan coils are delivered with standard
packaging made up from expanded
18
IFCLIJ 1805 - 4528500_09
the fan coil. Do not spray water on interior
or exterior surfaces of the fan coil (danger
of short circuits).
CLEAN THE FILTER PERIODICALLY
Frequent cleaning of the filter will ensure
more efficient unit operation.
Check whether the filter is very dirty: if
this is the case, repeat the operation more
often.
Use a suction device to remove built up
dust.
After cleaning and drying the filter, fit it
onto the fan coil by following the removal
procedure in reverse order.
EXTRAORDINARY CLEANING
The possibility to remove the fan augers,
which can be inspected (can only be
performed by staff with specific technical
skill) allows to carefully clean the internal
parts. This is a condition necessary in very
busy places or places that require high
hygiene standards.
DURING OPERATION
always leave the filter mounted on the fan
coil during functioning, otherwise the dust
present in the air will dirty the coil surface.
IT IS NORMAL
During cooling, water vapour may be
present in the flow air of the fan coil.
In the heating mode it might be possible
to hear a slight hiss around the fan coil.
Sometimes the fan coil might give off
unpleasant smells due to the accumulation
of substances present in the environment
air (especially if the room is not ventilated
regularly, clean the filter more often).
During functioning, noises and creaks may
be heard inside the device, due to the
various heat expansions of the elements
(plastic and metal), but this does not
indicate any malfunctioning and does
not cause damage to the unit unless the
maximum input water temperature is
exceeded.
polystyrene shells and cardboard.
FUNCTIONING ANOMALIES
In the case of functioning anomalies,
remove the voltage from the unit and then
re-apply it and re-start the appliance. If the
problem persists, call the Area After-sales
Service immediately.
DO NOT PULL THE ELECTRIC CABLE
It is very dangerous to pull, step on, crush
or fix the electric power supply cable using
nails or staples.
The damaged cable can cause short circuits
and injury to persons.
DO NOT INTRODUCE OBJECTS INTO THE
AIR VENTS
Do not introduce any type of object into
the air outlet slots.
This could cause injury to persons or
damage the fan.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or
mental capabilities or lack of experience
and knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by children without supervision
19
20
21
22
23
25
30
71
73
75