Troubleshooting; Scrapping - Nilfisk SR 1601 B Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Problem
The machine does not move
The main broom does not turn
The machine collects little debris/dust
The side broom does not work
The hopper dumping door does not
close
The fi lter shaker motor does not work
The dust guard system (optional)
does not work
(*) Procedure to be performed by Nilfi sk Service Center.
For further information contact a Nilfi sk Service Center, where it is possible to consult the Service Manual.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Batteries
– Polyester dust fi lter
– Main and side brooms
– Hydraulic system oil
– Hydraulic system oil fi lter
– Plastic components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk Center especially when scrapping electrical and electronic components.
30
USER MANUAL
Possible cause
The batteries or the connector are
disconnected
The batteries are discharged
The fuses are tripped
The parking brake is engaged
The unlocking screw is not in a proper position Turn it properly
The main broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The vacuum system is off
The dust fi lter is clogged
The hopper is full
The skirts are damaged or misadjusted
The main broom height is incorrect
The fuses are tripped
The side broom is lifted
Debris wrapped around the broom drive
The hopper is not fully lowered
The dumping door is jammed by debris
The fi lter shaker motor connector is not
properly connected
The fuse is tripped
The switch is faulty
The nozzles or the water fi lter are clogged
The pump is faulty
The fuse is tripped
33019318(2)2010-09 A
Connect the batteries or the connector
Charge the batteries
Reset any tripped fuse
Disengage
Lower the main broom with the lever
Remove debris
Fully lower the hopper
Turn on the vacuum system with the switch
Clean the dust fi lter
Empty the hopper
Check the skirt for integrity and proper adjustment (*)
Adjust the main broom height
Reset any tripped fuse
Lower the side broom with the lever
Remove debris
Fully lower the hopper
Remove debris and clean edges of dirt chamber
Connect it properly
Reset the tripped fuse
Replace the switch (*)
Clean
Replace
Reset the tripped fuse
SR 1601 B
Remedy