Nilfisk SR 1601 B Manuel D'utilisation page 67

WARNING!
– Carefully read all the instructions before performing any maintenance/repair procedure.
– When working near the hydraulic system, always wear protective clothes and safety glasses.
– Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine
moving parts.
– When the machine is equipped with lead batteries (WET), do not smoke while charging the batteries.
– To avoid any unauthorised use of the machine, remove the ignition key.
– Do not leave the machine unattended without being sure that it cannot move independently.
– Do not use the machine on slopes with a gradient exceeding the specifi cations.
– Use only brooms supplied with the machine or those specifi ed in the User Manual. Using other brooms could
reduce safety.
– Before using the machine, close all doors and/or covers.
– Use the machine only where a proper lighting is provided.
– If the machine is to be used where there are other people besides the operator, it is necessary to install the
pivoting light and the reverse gear buzzer (optional).
– Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
– Do not use compressed air to clean this type of machine, except for the fi lters (see the relevant paragraph).
– While using this machine, take care not to cause damage to people and children especially.
– Do not lean liquid containers on the machine, use the relevant can holder.
– The machine storage temperature must be 0°C to +40°C.
– The machine working temperature must be 0°C to +40°C.
– The humidity must be between 30% and 95%.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity
condition. Store the machine indoors, in a dry place. This machine must be used in dry conditions, it must
not be used or kept outdoors in wet conditions.
– Do not use the machine as a means of transport, or for pushing/towing.
– Do not allow the brooms to operate while the machine is stationary to avoid damaging the fl oor.
– In case of fi re, use a powder fi re extinguisher, not a water one.
– Do not bump into shelves or scaffoldings, particularly where there is a risk of falling objects.
– Adjust the operation speed to suit the fl oor conditions.
– Avoid sudden stops when the machine is going downhill. Avoid sharp turns. Drive at slow speed when going
downhill.
– This machine cannot be used on roads or public streets.
– Do not tamper with the machine safety guards.
– Follow the routine maintenance procedures scrupulously.
– Do not remove or modify the plates affi xed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. Otherwise, request
assistance from the authorised personnel or from an authorised Service Center.
– In case of part replacement, order ORIGINAL spare parts from an authorised Dealer or Retailer.
– To ensure the proper and safe operation of the machine, have the scheduled maintenance, detailed in the
relevant chapter of this Manual, performed by the authorised personnel or an authorised Service Center.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries,
oil, plastics, etc.), which are subject to standards that require disposal in special centres (see Scrapping
chapter).
SR 1601 B 33019318(2)2010-09 A
USER MANUAL ENGLISH
5