Pre-Operational Checklist; Main Broom; Operating The Machine; Before Starting The Machine - Nilfisk SR 1601 B Manuel D'utilisation

PRE-OPERATIONAL CHECKLIST

Before Each Use:
– Check the machine for damage or oil leaks.
– Check the hydraulic system oil level (19) (see the relevant paragraph).
– Insert the key and turn the ignition switch (57) to "I" and check the battery warning light (51):
• If all LEDs (51) turn on, the batteries are charged.
• If some yellow LEDs turn on, or the red LED turns on, the batteries must be charged (see the procedure in Maintenance
chapter).
In the driver's seat:
– Be sure to understand the operating controls and their functions.
– Adjust the seat with the lever (40) to allow easy reach of all controls.
– Insert the ignition key (57) and turn it to "I":
• Check the horn (58), hour counter (56) and headlights (61, optional) for proper operation.
• Turn the ignition key (57) to "O".
– Check the parking brake (35 and 36). The brake must hold its (locked parked) setting fi rmly without easily being released
(report all defects immediately to service personnel).
Plan cleaning in advance:
– Arrange long runs with a minimum of stopping or starting.
– Allow a small amount of broom path overlap to ensure complete coverage.
– Avoid making sharp turns, bumping into posts, or scraping the side of the machine.

MAIN BROOM

Several different main brooms are available for this machine. To select the best broom for the surface and litter to be swept, contact
a Nilfi sk Retailer.
NOTE
To install the main broom, refer to Main Broom Maintenance paragraph.

OPERATING THE MACHINE

The SR 1601 is a rider-type automatic fl oor sweeping machine. The controls were designed to be user friendly. For single pass
sweeping the operator can simply lower the main broom.

BEFORE STARTING THE MACHINE

1. Be sure to understand the operating controls and their functions.
2. Plan the cleaning route. Arrange long, straight passes with as few turns as possible.
3. Check the brake pedal (35). The pedal should be fi rm.
WARNING!
If the pedal is "spongy" or fades under pressure, do not drive the machine.
Report all defects immediately to service personnel.
SR 1601 B 33019318(2)2010-09 A
USER MANUAL ENGLISH
15