Safety; Symbols; General Instructions - Nilfisk SR 1601 B Manuel D'utilisation

ENGLISH

SAFETY

The following symbols indicate potentially dangerous situations. Always read this information carefully and take all necessary
precautions to safeguard people and property.
The operator's cooperation is essential in order to prevent injury. No accident prevention program is effective without the total
cooperation of the person responsible for the machine operation. Most of the accidents that may occur while working or moving
around are caused by failure to comply with the simplest rules for exercising prudence. A careful and prudent operator is the best
guarantee against accidents and is essential for successful completion of any prevention program.

SYMBOLS

DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates that it is necessary to consult the User Manual before performing any procedure.

GENERAL INSTRUCTIONS

Specifi c warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
– Before performing any maintenance, repair, cleaning or replacement procedure disconnect the battery
connector, remove the ignition key and engage the parking brake.
– This machine must be used by properly trained operators only.
– Sharp turns must be made at slowest possible speed. Avoid: abrupt turns on incline, turns when the hopper
is lifted.
– Do not lift the hopper when the machine is on incline. The machine loses stability on incline or when the
hopper is full.
– Do not wear jewels when working near electrical components.
– Keep the battery away from sparks, fl ames and incandescent material. During the normal operation explosive
gases are released.
– Do not work under the lifted machine without supporting it with safety stands.
– When working under the open hood, ensure that it cannot be closed by accident.
– Do not operate the machine near toxic, dangerous, fl ammable and/or explosive powders, liquids or vapours:
This machine is not suitable for collecting dangerous powders.
– If the machine is equipped with lead (WET) batteries, battery charging produces highly explosive hydrogen
gas. Keep the hood open when charging the batteries and perform this procedure in well-ventilated areas
and away from naked fl ames.
– When lead batteries (WET) are installed on this machine, do not tilt the machine more than 30° from its
horizontal position to prevent the highly corrosive acid to leak out of the batteries. When the machine is to
be tilted to perform maintenance procedures, remove the batteries.
4
USER MANUAL
33019318(2)2010-09 A SR 1601 B