Characteristics Of The Regulation - AERMEC MODUCONTROL Manuel D'utilisation

Characteristics of the regulation

The command panel of the unit allows
the rapid setting of the working parame-
ters of the machine, and their visualisa-
tion. The display consists of 4 fi gures
and various LEDs for indicating the type
of operational mode, the visualisation of
the parameters set and of any alarms
triggered. The card stores all the default
settings and any modifi cations. With
the installation of the PR3 remote panel
accessory, it is possible to control the
switching on and off from a distance,
as well as the setting of the operational
mode (cooling-heating), and the visuali-
sation of the alarm summary.
Modu_485A adding the accessory, the
unit can be managed in a VMF, or be
managed via a BMS via Modbus proto-
col. After the absence of voltage for any
period of time, the unit is able to start
up again automatically, maintaining the
original settings.
Index
1
2
Board for probes, valves and communication management with inverter
3
4 Board for inverter compressor management
5
6
ATTENTION: If you wish to implement a BMS management system, a manual is available on our site
www.aermec.com with all specifications necessary for the realisation of a serial supervision system.
ModBUS
Element
Moducontrol Board
Command interface on the machine
module
Simplified remote panel
ModBus protocol interface board
5
2
1
Modu 485A
6
4 3
Notes
Present on ANLI units only
Present on ANLI units only
Accessory PR3
Modu_485A accessory
EN
IMDCFJ. 12.05 6343841_03
43