Remote Control; Technical Specifications - afx light 15-1674 Manuel D'utilisation

6. To finalize the pairing procedure press once again the Reset button on the transmitter. The LEDs will first flash
and then remain steadily lighted (blue on the transmitter and green on the unit). Transmitter and receiver are
now paired.
7. Repeat steps 4 to 7 for every new projector that needs to be paired.

REMOTE CONTROL

If you wish to use the remote control, you have to set the IR feature to ON.
[BLACK]: Press BLACKOUT button and fixture will shut down. None of the other
buttons will work anymore. Press BLACKOUT again and fixture will light up. All other
buttons will work again normally.
[AUTO]: Press AUTO and then [+]/[-] to select AUTO mode. Press SPEED and [+]/[-]
to select the speed of the auto mode between 0 – 255.
[STROBE]: Press STROBE button and then [+]/[-] to select the speed of the strobe.
[SPEED]: Only valid after having pressed AUTO. The speed is selectable between 0
and 255.
[SENSITIVITY]: Sensitivity is used in EDIT effect mode
[%]: Press % and [+]/[-] to adjust brightness
[FADE]: Gradient effect
[MANUAL]: Press MANUAL and then [R], [G], [B], [W], [A] using the [+]/[-] buttons
to adjust the color's brightness.
Number buttons 0-9: Direct selection of the color corresponding to the number.
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure that the light is power off before dismantling or maintaining, it's very important to keep the light
clean. Frequent cleaning will ensure maximum brightness output, but also prolong the life time. It's suggested to use
the high quality, professional glass detergent and soft cloth to clean the light. It's not allowed to use alcohol or
chemical solvent. The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn't work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.

TECHNICAL SPECIFICATIONS

LED ............................................................................ 4 x 15W RGBAW 5-en-1
Power ......................................................................................................... 60W
Input voltage .................................................................... 110-220Vac 60/50Hz
Battery voltage ........................................................................................ 21Vdc
Battery capacity ................................................................................... 8000mA
Charging time........................................................................................ 5 hours
Discharge time at full output ................................................................. 6 hours
© Copyright LOTRONIC 2016 PARLED-W15 Page 11