Carrying The Wheelchair; Mounting The Rear Wheels; Unfolding The Wheelchair; Mounting Or Removing Of The Footrests - Vermeiren Eclips X4 Mode D'emploi

All manuals and user guides at all-guides.com
2 Use
This chapter describes the everyday use. These instructions are for the user and the
specialist dealer.
The wheelchair is delivered fully assembled by your specialist dealer. The instructions
intended for the specialist dealer on how to set up the wheelchair are given in § 3.
2.1

Carrying the wheelchair

The best way to carry the wheelchair is to make use of the wheels and roll the wheelchair.
If this is not possible (e.g. when the rear wheels are taken off for transportation in a car),
firmly grasp the frame on the front and the grips. Do not use the foot or arm supports or the
wheels to grasp the wheelchair.
2.2

Mounting the rear wheels

2.3

Unfolding the wheelchair

L L L L
CAUTION:
Risk of clamping – Keep fingers away from moving parts of the
wheelchair.
1. Position yourself behind the wheelchair.
2. Use the handgrips to open the wheelchair as much as possible.
3. Position yourself at the front of the wheelchair.
4. Push both seating tubes down till they are fixed in their position.
5. When the pushbaris available mount the pushbarto the right handle.
2.4

Mounting or removing of the footrests

1. Take the rear wheel and push on button
2. Keep the button pushed in and mount the rear
wheels axle till it stops.
3. Release the button.
4. Check that the wheel is secured.
The mounting of the footrests is done as follows:
1. Hold the footrest sideways at the outside of the
wheelchair frame and mount the tube hood
into the frame.
2. Swing the footrest inwards till it clicks in
position.
3. Swing the foot plate downwards.
To take off the footrests:
1. Pull handle .
2. Swing the footrest to the outside of the
wheelchair till it comes loose from the guidance.
3. Pull the footrest tube hood
frame.
Page 8
Eclips X4, Eclips X4 30°
2012-01
.
out the wheelchair