Operation; Cleaning - ZUMEX SPEED SELF-SERVICE Manuel De L'utilisateur

MANUAL SpeedSelf&Cooler 26/10/07 12:24 P gina 16

4.2 OPERATION

Operation of the models:
• Fill in the orange feeder and place a glass or jug under the juice outlet.
• The machine has a MAN/AUTO selector that provides two operation modes:
In the MAN mode, the machine will operate when the tap is used.
In the AUTO mode, the machine will operate with the ON/OFF push-button
Operation of the model:
• Fill in the orange feeder.
• Press the ON (green) push-button. The photocells will detect the absence of juice
in the deposit and the machine will be started automatically. The juicing process will
continue until the photocells detect the juice level selected.
• Start the cooling group by pressing the push-button placed on the left of the juice
outlet of the deposit. You can adjust the temperature of the juice with the regulation
device located at the right; turn it clockwise to increase the cooling level and counter-
clockwise to reduce it.
• Press the lever of the deposit to fill a glass or jug. After one service, the level of the
deposit will go down and the machine will start automatically until a new deposit is
filled to the desired level. To stop the automatic juice detection process, press the OFF
(red) push-button.
30
Zumex Speed Self-Sevice
Zumex Speed Self-Sevice Podium
Zumex Speed Cooler Podium

4.3 CLEANING

The following steps must be carried out for the correct cleaning of the unit:
1-Disconnect the machine.
2-Disassemble the front cover.
3-Disassemble the cutter head (Fig. 6) pulling towards you, from the
handle. WARNING this element is very dangerous, handle with
care.
4-Remove the peel extractors from the supports (Fig. 7).
5-Disassemble the pressing units in pairs, previously removing the
security knobs (Fig. 8).
6-Disassemble the container and juice filter (Fig. 9 and Fig. 10).
7- In the models with a base stand, disassemble the peel deposit, and
deposit in the case of Zumex Speed Cooler Podium.
• All items, EXCEPT FOR THE FRONT COVER AND THE ZUMEX SPEED COOLER PODIUM
CONTAINER, can be washed with a dishwasher.
• Clean the juicing area and cover with a soft cloth, dampened with water and soap
suitable for tableware.
• Next, rinse with water to ensure there is no soap.
• After cleaning, assemble all elements in the inverse disassembly order. Make sure
that all parts are correctly adjusted and secured. Check all parts to ensure that they
are correctly assembled and fixed.
• To clean the inside of the stainless steel tap, fill in the container with clean water
and press the tap to remove the remains of juice and pulp inside the tap. To guarantee
a better cleaning process, disassemble the tap from the stainless steel container.
• Remember that each peel ejector (Fig. 8) can only be fitted on each side, since they
can not be fitted on the incorrect side. The wedge paddle must be inserted until it
reaches the end in the male juicing drum opening.
EN
31