Operation - ZUMEX HORECA & FOOD Minex Manuel De L'utilisateur

MANUAL USUARIO MINEX 11/9/06 17:27 P gina 12

4.2 OPERATION

Once the unit has been plugged to the power supply:
1. Operate the button on rear of the machine (Fig. 2) and it will be ready to work.
The oranges of the ramp are dosed automatically to the squeezing system where they
are cut and squeezed, the two halves sequentially, in the pressing units. The juice will
deposit in the juice tray or in the juice jar and the peel in the peel bucket.
2. Feed the ramp with the oranges you want to squeeze.
3. Press the ON/OFF button on the front of the machine (Fig. 3), the squeezing process
starts automatically. You can stop whenever you want pressing the ON/OFF switch.
The machine will also stop automatically few seconds after it doesn't detect any
orange entering.
ATENTION:
Your machine can work with the
jar or a glass.
If you are working with the jar:
* While squeezing, the juice will be
filling up the jar.
* The jar and peel bucket capacity are
limited and equivalent approximately
to two complete charges of the feeder.
* The Jar capacity is 0.75l/ 0.25oz
22
If you are working with a glass:
* While squeezing, the juice will
be filling up juice tray.
*The capacity of the juice tray is
0.5 l / 0.17 oz
*Pour the juice placing the glass on
the base under the faucet and
working the "PRESS" button (Fig. 4).
Operating mode & Display information
The machine can be in three different operating modes and depending on them, the
display of the machine can show the following information:
· Normal working mode: When the machine is running or ready to run, the display
shows the name and the orange counter.
EXAMPLE
MINEX
Ct000000
· Security stop mode: The machine has stopped automatically or does not work,
because one of the three security elements (cover, juice tray or peel bucket) is
missing or not placed correctly.
Of the five digits that appear in the 2nd line of the display, the last three give
information about the status of each one of the three elements. The digits can
have two values "0" or "1". If the display shows "0" this indicates that the element
is well placed. If the display shows "1" it is not placed or not placed correctly.
EXAMPLE
S E G
0 0 1 1 0
Peel bucket (OK)
Juice filter tray (NOT OK)
Frontal cover (NOT OK)
NOTE: The values of the two first digits give additional information to the after
sales service
Counter
EN
23