Selecting The Ironer Speed; Setting The Ironer Speed; Changing The Pre-Set Roller Speed For A Roller Speed Selection Button; Laundry Feed - Miele professional PM 1210 Mode D'emploi

en-CA - Operation
The temperature value is now saved for that
temperature selection button.
Useful tip: Allow the roller to rotate for
about 5 minutes to enable the heat to equal‐
ize between the heater plate and the roller.

Selecting the ironer speed

PM 1210 / PM 1214:
Symbol Speed range
Low speed range

Medium speed range
 
High speed range
  
PM 1217:
Symbol Speed range
 Low speed range
Medium speed range
 
High speed range
  
Roller speed can be selected either using
the preset speed ranges or directly by using
the "Increase roller speed"  or "Decrease
roller speed"  buttons.

Setting the ironer speed

Press the "Roller speed selection mode"

. button.
The button will then be highlighted with a
bar underneath.
Then press one of the three roller speed

buttons, e.g. the "Roller speed 2"   but‐
ton.
The button will then be highlighted with a
bar underneath and the ironer will operate at
the pre-set roller speed for this button.
14
Changing the pre-set roller speed for a
roller speed selection button
Press the roller speed button you want to

change the speed for.
Keep it pressed in. The bar will light up un‐
derneath it and the current roller speed will
appear in the display.
Press the "Increase roller speed"  or

m /
"Decrease roller speed"  button to set
min
the roller speed you want to save for that
1.5 - 2.2
button.
2.3 - 3.2
Then press and hold the selected roller

3.3 - 4
speed button (which is highlighted with a
bar underneath) until it flashes once.
The roller speed is now saved for that roller
speed button.
m /
Then press the  button.

min
1.5 - 2.4

Laundry feed

2.5 - 3.4
Lay the item parallel to the roller at the be‐

3.5 - 4.5
ginning of the laundry infeed table.
Smooth the item.

Feed the item into the machine.

Useful tip: Do not restrict ironing of smaller
articles to any one part of the roller. Make
use of the whole roller width. If laundry is
continuously fed in on one side of the roller
an infeed fault symbol will appear in the dis‐
play (see display symbol  on the control
panel).

Pauses in ironing

Press the "Pause"  button to go into

Pause mode.
The heater plate is disengaged and the roll‐
er comes to a standstill. The heating will re‐
main turned on.
Press the  button to start ironing again.

The ironer remains ready to operate in
Pause mode. If it is not used for a period of
10 minutes the temperature is reduced to
60°C (140°F).