En - Warning And Safety Instructions; Correct Application; Technical Safety - Miele professional PB7895ms Mode D'emploi

en - Warning and Safety instructions

The Aqua Purificator G 7895 and
Conductivity module C comply with
all relevant safety requirements. In-
correct use can, however, lead to
personal injury and damage to
property.
To avoid the risk of accidents and
damage to these appliances please
read these instructions carefully be-
fore starting to use them. They
contain important notes on the
installation, safety, operation and
care of the appliances.
Keep these instructions in a safe
place for reference, and pass them
on to any future user.

Correct application

~
The Aqua Purificator G 7895 and
Conductivity module C are designed for
specialised applications only, and must
only be used as described in these in-
structions. Alterations or conversions to
the appliances, or using them for
purposes other than those for which
they are designed are not permitted
and could be dangerous.
The manufacturer cannot be held liable
for damage caused by improper or
incorrect use.
~
Personnel operating the appliances
should be trained regularly. Untrained
personnel should not be allowed
access to the appliances or their
controls.
22
~
These appliances are not intended
for use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience or knowledge, unless they
have been shown how to use them
correctly by a person responsible for
their safety.

Technical safety

~
The Aqua Purificator G 7895 and
Conductivity module C must be
checked for any visible damage before
they are installed. Do not install and use
a damaged appliance. A damaged
appliance is dangerous.
~
The G 7895 should be
commissioned and then maintained
only by a Miele authorised and trained
service technician or other suitably
qualified and competent approved
person.
~
The electrical safety of this
appliance can only be guaranteed if
connected to a correctly installed
earthing system on site. It is most
important that this basic safety
requirement is present and regularly
tested, and where there is any doubt
the on-site wiring system should be
inspected by a qualified electrician.
The manufacturer cannot be held liable
for damage or injury caused by missing
or defective earthing, such as electric
shock.