Güde GRT 350 TA Mode D'emploi Original page 21

GRT 420 T # 94008 operating set-up
Fig. 14
Reel Replacement
Fig. 15
Operation set-up:
A. Working height set-up
B. Mowing head position
C. Handle bent
D. Handle height
An optimum working height may be set-up by turning the
telescopic rod upper part to the right. To fix the set-up, the
rod has to be turn to the left.
Upon turning the clamping wheel to the right, the handle
may be put in the required position. To lock the handle in
the position, the wheel must be turn to the right again.
Pedal the foot lever down to set the bent of the guide tube.
Switch off the machine first, wait for the nylon spring to stop
completely and unplug. Take the reel, turn it to the left
holding the reel on the motor until it separates from the
latter. Remove the empty reel and put a new one on. Line
up the hole in the reel centre on a flexible pin, press the reel
and turn it to the right until it fits in.
21
GB