Patient Placement And Nursing Care; Cpr; Skin Care; Incontinence / Drainage - arjo AtmosAir 4000 Série Mode D'emploi

Patient Placement and Nursing Care

It is recommended that all sections of this User Guide be read prior to product use.
Carefully review the Contraindications, Safety Information and Risks and Precautions
sections prior to placing a patient on any AtmosAir MRS.
1. Transfer patient following all applicable safety rules and institution protocols.
2. Center patient side-to-side and head-to-foot on AtmosAir MRS surface.
3. Ensure all sections of the mattress fully support the patient.
Mattress handles are for mattress transport only.

CPR

1. Level bed.
2. Lower or remove side rail on caregiver's side if necessary.
3. Begin CPR as per facility protocol. Consider use of backboard if indicated.
4. After CPR is performed:
• Remove backboard if used.
• Raise or install side rail as necessary.
• Recon gure bed and accessories as in initial placement.

Skin Care

• Remove excess moisture and keep skin dry and clean.
• Check patient's skin regularly, particularly in areas where incontinence and drainage
occur.
• Ensure linens under patient are not wrinkled.

Incontinence / Drainage

• Use moisture-impermeable underpads for incontinent patients.
• Wipe surface clean and replace bed linens as required (see Care and Cleaning).

General Operation

Avoid contact of sharp instruments with the AtmosAir MRS. Punctures,
cuts and tears may prevent proper in ation and air pressure
maintenance.
EN
Figure 4
7