Base Plate - Rohm CAPTIS-M Traduction Du Manuel D'utilisation Original

8. Place the collar nuts of the studs against the bayonet disk and tighten
with a spanner.
9. Check radial and axial run-out on the check collar of the chuck and align
if necessary.
 Flange mounted.

5.2.4 Base Plate

1. Clean the mating surfaces of the collet chuck CAPTIS-M and of the
base plate.
122017 / 1.0
For base plate, see Chapter 5.4 Optional Accessory, page 76.
Assembly
73