Rohm CAPTIS-M Traduction Du Manuel D'utilisation Original page 74

3. Put machine into set-up mode.
4. Clean the fitting surfaces of the machine spindle.
5. Check the fitting surfaces of the machine spindle for radial and axial
run-out.
6. Place the collet chuck CAPTIS-M with the flange on the spindle in
the correct position so that the rotation lock of the spindle and the
positioning grips in the flange and the bayonet disk can be inserted.
7. Turn the bayonet disk counter-clockwise, as seen from the machining
area of the machine, until it is flush with the spindle.
122017 / 1.0
Assembly
72