Switching the date on/off
Fig. 13: Switching the date on/off
1.
In Standby mode, press the [SETUP] button on
the device or the remote control.
The display shows the [Set Time] menu
(Fig. 11).
2.
Turn the click wheel until [Display Date] is
shown.
3.
Press the click wheel.
Now you can switch the date on or off.
8.3
Settings menu
In operating mode, the following configurations can
be made in the [Settings] menu:
When the device is switched on, you can make the
following configurations in the [Settings] menu:
Set the time format.
Set the date format.
Setting display dimmer
Setting alarm light (only with sonoroLIGHT).
Set the automatic time/date update function.
Set the display language.
Activate/deactivate Demo Sound.
Reset the device to the factory settings.
To adjust the settings, proceed as follows:
1.
Press the [SETUP] button on the front of the
device or the remote control to enter the corre-
sponding submenu.
2.
Press the [Next] or [Previous] button or turn the
click wheel to scroll through the individual menu
items.
3.
To open the selected menu item, briefly press
the click wheel or the [OK] button on the remote
control.
4.
To exit the menu, briefly press the [MENU]
button on the device or on the remote control.
i
If you do not make any further entries, the menu
will close and the display switches to the previous
mode.
Setting the time format
Fig. 14: Setting the time format
You can choose between the 24-hour and 12-hour
formats. In the 12-hour format, the time of day is
indicated by [AM] and [PM].
Setting the date format
Fig. 15: Setting the date format
You can set three different date formats (Fig. 15/A, B
und C) as well as the current day. The configuration
options are:
A: Current day, day, month, year.
B: Current day, month, day, year.
C: Current day, month (in words), day, year.
Setting display dimmer
Fig. 16: Setting display dimmer
Depending on the ambient brightness, the display is
switched to bright or dark. The ambient brightness is
detected by a sensor beside the display.
You can set the desired brightness level.
Display High: Level 08 to 15 (Fig. 16/A)
Display Low: Level 01 to 08 (Fig. 16/B)
To this end, you can proceed as follows to set the
desired brightness of the alarm light and the time-
frame in which the alarm light should reach this
brightness:
95