Connecting The Antenna; Preparing The Remote Control; Connecting Sonorolight - Sonoro SO-320 Mode D'emploi

L WARNING!
Risk of injury if handled incorrectly!
Risk of electric shock if the mains cable is handled
incorrectly.
– Pull the mains cable straight out of the outlet.
L NOTICE!
Risk of damage to equipment in the event of
incorrect power connection!
Connection ratings that exceed the maximum per-
missible values of the device can destroy it.
– Only use the mains cable supplied with the
device.
– Only use the device if the indicated voltage cor-
responds with the voltage of your mains socket.
1.
Insert the plug of the mains cable into the
power socket on the back of the device.
2.
Insert the mains plug in the outlet.

7.4 Connecting the antenna

The scope of supply contains a cable antenna and a
rod antenna. For optimum radio reception, you must
use one of the two antennae.
1. Screw the desired antenna located on the back
of the device to the DAB/FM antenna connector.
Fig. 9: Aligning the cable antenna
2. Unfold the cable antenna or pull the arms of the
rod antenna apart and align the antenna so that
you have the best possible reception.
i
For good FM/DAB radio reception, the two ends of
the cable antenna should form a "T" (dipole) with
the connecting cable.
– Fig. 9/A: Recommended alignment for FM
– Fig. 9/B: Recommended alignment for DAB
For even better reception, attach the cable to a
suitable house antenna.
7.5

Preparing the remote control

Fig. 10: Inserting the battery in the remote control
1.
Open the battery compartment of the remote
control (Fig. 10).
2.
Insert the supplied button celle (CR2032, 3 V)
with the label side (+) up.
3. Close the battery compartment.

7.6 Connecting sonoroLIGHT

In order to be able to control a lamp using the Blue-
tooth function, you must connect sonoroLIGHT and
sonoroSTEREO 2 once. Connected devices are
stored and later connected automatically.
i
Follow the sonoroLIGHT operating instructions.
1.
Plug sonoroLIGHT into a socket.
2. Ensure that sonoroLIGHT and sonoroSTEREO 2
are no more than 10 m away from one another.
Other-wise, no connection can be established.
3. Press the button on your sonoroLIGHT.
 sonoroLIGHT searches for another Bluetooth
device.
4.
Press the [Light] button on your sonoroSTEREO 2
and hold it for 3 seconds.
 The devices are connected to one another.
No password needs to be entered. Once the
devices are successfully connected, the
[Light] button lights up in white.
93