3.
Press the click wheel to confirm the entry.
When the specified time expires, playback gradually
fades out.
Dimming light (sunset)
In addition to a Sleep Timer, you can also dim or
switch off a connected lamp (only in conjunction with
sonoroLIGHT).
1.
Ensure that sonoroLIGHT is connected and that
its dimmer function is switched on.
2.
Switch on the light
light on and off' on page 98.
3.
Program a Sleep Timer.
After the Sleep Timer has elapsed, the light is
reduced gradually and is switched off after
40 seconds.
i
If you press the [Standby] button during
the Sleep Timer, the light remains
switched on.
If you press the [Light] button while the
light is being dimmed, the light is
switched off immediately.
8.7 Switching the light on and off
You can switch a connected lamp on and off (only in
conjunction with sonoroLIGHT).
1.
Ensure that sonoroLIGHT is connected and that
its dimmer function is switched on.
Fig. 26: Switching on the light
2.
Press the [Light] button on the device or the
remote control.
The light is switched on (brightness level 8)
and the display shows the
text[sonoroLIGHT On] (Fig. 26).
Fig. 27: Setting the brightness
98
Chapter 8.7 'Switching the
3.
Turn the click wheel within 4 seconds to set the
brightness of the light (level 00 to 32, Fig. 27).
i
If the device is turned off, you can wait
longer.
4.
Press the [Light] button again to switch the light
off.
If the device is turned off, you can turn the click
wheel directly to switch the light on and set the
brightness.
9
Alarm function
You can use the device to wake up with FM/DAB
radio, CD, Relax Music or alarm ringtones. The alarm
functions can also be set in the device's Standby
mode.
The alarm setup menu is structured as follows:
'Set the Alarm Time Set the Alarm Source
Set the Alarm Volume Set the Alarm Repetition
End'
i
If you do not press any buttons for approx.
10 seconds when setting the alarm, the setting is
terminated without saving it.
9.1 Setting the alarm time
Fig. 28: Setting Alarm 1
1.
Keep the [Alarm 1] or [Alarm 2] button pressed.
The display shows the [Set Alarm 1] (Fig. 28)
or [Set Alarm 2] menu.
2.
Turn the click wheel to set the hours.
3.
Press the click wheel to confirm the entry.
The minute display flashes.
4.
Turn the click wheel to set the minutes.
5.
Press the click wheel to confirm the entry.