Aprimatic Flexi 300EL Manuel D'instructions page 29

14 - INCONVENIENTS AND REMEDIES
14A - THE AUTOMATION DOESN'T START
- Verify the presence of voltage in the terminals of the external fuse box.
- Verify the fuse (see paragraph 1A).
- STOP contact open (red led "ST" is off): check for possible STOP commands connected (terminal 14). If absent, jumper the
input with terminal 14.
14B - THE AUTOMATION PERFORMS ONLY THE OPENING CYCLE
-The photocell is obstructed (red led "PHO" is off): check the correct positioning of the photocells and their range.
-The photocell is absent (red led "PHO" is off): if there are no devices connected on terminal 16, jumper the input.
-A normally closed contact, or a defective contact, is connected on "STAR" input (terminal 12 – the green led "START" is steady
on).
14C - THE AUTOMATION WORKS ONLY BY WIRE
- The radio transmitter hasn't been correctly programmed (see paragraph 3).
- The battery of the transmitter are exhaust. Change them.
14D - THE AUTOMATIONS CLOSES WITHOUT EXTERNAL COMMANDS
- The automatic reclosing dip "AUTO" is ON. Put the dip in OFF (see paragraph 4A).
- The rapid reclosing dip "FAST" is ON. Put the dip in OFF (see paragraph 4A)
14E - THE AUTOMATION STARTS BUT, AT A CERTAIN POINT, IT INVERT THE TRAVEL
- Too low obstacle sensitivity. Increase the "OBS" trimmer (see paragraph 4B).
- Check the motors: they should turn off some seconds after the beat. In case, lower the OBS trimmer (see paragraph 4B), and
perform the programming procedure again.
- Intervention of safety devices. If there are two pairs of photocells, they could see each other. Invert a receiver with its transmit-
ter (see paragraph 11A).
14F - THE AUTOMATION STARTS BUT, AT A CERTAIN POINT, IT STOPS
- Not enough power. Set "FOR" trimmer at maximum level, and program the automation again (see paragraph 4B). Perform a
professional programming procedure (paragraph 5D) and reduce at minimum (or remove) the slowdowns.
14G - LIMITED SEGNAL RECEPTION
- An external antenna has been connected, but the standard cable mounted in the control unit hasn't been removed. Remove
the cable.
- The battery of the transmitter are exhaust. Change them.
- There are external interferences. Install an external antenna.
14H - THE WINGS, IN CLOSING POSITION, ARE NOT ENOUGH BLOCKED
- Increase the "OBS" trimmer, in order to push more the wings against the mechanical stop and perform the programming
procedure again.
14I - THE MANUAL RELEASE IS TOO HARD
- The mechanism is too stressed in closing position. Decrease the "OBS" trimmer, and perform the programming procedure
again.
14L - THE RED LED "ERR" TURNS ON, AND THE CONTROL UNIT DOES NOT ACCEPT INPUT
- Perform a programming procedure (see paragraph 6B or 6D). Then try again.