Aprimatic Flexi 300EL Manuel D'instructions page 23

6D - PROFESSIONAL LEARNING PROCEDURE
The installer can set the beginning point of the slowdown through this procedure. The beginning point is
customizable in opening and closing.
On steps 9a and 12a of the programming procedure, the first wing is the one which opens as first and
!
closes as second (connected to terminals 24, 25 "MOT1").
The second wing, instead, is the one which opens as second and closes as first (connected to terminals
26, 27 "MOT2").
1. Place the wings in
middle position.
6. It closes the first wing,
and then it closes the second
wing. Intervention of the
mechanical stop or the electric
limit switch. End of closing.
7. Push SET button or a button
of the radio transmitter.
The control unit performs
the opening.
END of learning
(yellow led turns off)
12b. Mechanical stop
intervention or of
the electric limit switch.
End of closing.
After the programming procedure, see also paragraph 6C for the starting.
!
2. RESET: push the
SET button for
2 seconds.
5.The control unit perform a little
opening cycle at low speed (if the
motors go in the opposite direction,
invert the motor phases and the
eventual limit switches phases.
8. Do you want
deceleration during
opening?
9a. Choose the point of slow-down
with the button SET or the button 1
of the transmitter for the first wing,
and with the button RADIO or the
button 2 of the remote control
for the second wing.
11. Do you want
NO
deceleration during
closing?
12a.
Choose the point of slow-down
with the button SET or the button
1 of the transmitter for the first
wing, and with the button RADIO
or the button 2 of the remote
control for the second wing.
3. The yellow led
flashes.
4. Push the RADIO button
for 1 second within 5
seconds (the yellow led
switches on).
NO
9b. Intervention of the
mechanical stop
or of the electric limit
switch.
End of opening.
10. Push SET button or a
button of the radio transmitter.
The control unit performs the
closing.