Testing Remote Flash Mode; Servo Mode; Setting Servo Flash Mode - Metz mecablitz 64 AF-1 digital Mode D'emploi

10.3 Testing remote flash mode

• Place the slave flash units in the desired
• Wait for all of the flash units involved to
• Press the manual firing button
The flash mode is transmitted automatically
by master.
k
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
188
positions for the shot. Use flash unit moun-
ting foot S60 to set up the slave flash unit.
become flash ready. Once the slave flash
units are flash ready, the AF auxiliary ligh
will blink.
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the sla-
ve flash unit so that it is able to receive
light from the master flash unit via the sen-
sor
.
on the
ETTL
0.8- 9.0 m
M-
5,6
35 m
F
Zoom
m
EV
MODE
REMOTE SLAVE
SERVO
p
q
SYNC
M-Servo
M-
Zoom 35
m
m
P
1/1

10.4 SERVO mode

SERVO mode is a simple slave mode without
or with complete pre-flash suppression in
which the slave flash unit always triggers a
flash as soon as the camera flash unit recei-
ves a light pulse.
In SERVO mode, only manual flash mode is
possible. Manual flash mode is automatically
activated after switching to SERVO mode.

10.4.1 Setting SERVO flash mode

• Press the sensor button of the displayed
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
O
• Press the sensor buttons on the
touch display and select
• Press the SERVO sensor button on the
touch display.
The mode of operation is adopted.
If desired, partial light output can be set,
see 10.4.3.
SERVO
.