10.2.4 Set slave mode
REMOTE
RMT CH
SLAVE
• Press the sensor button on the touch
2
2
display for the partial light output/exposu-
Z
35 mm
re correction (e.g.
OOM
for the selection appears.
INFO
1/1
• Press the sensor button on the touch
TTL
display for the desired mode of operation
M
TTL
1/1
The setting is applied automatically.
10.2.5 Setting partial light output/exposure
REMOTE
RMT CH
SLAVE
2
2
• Press the sensor button on the touch
display for the partial light output/exposure
Z
35 mm
OOM
correction (e.g
k
the selection appears.
INFO
1/1
• Press the sensor button on the touch
display for the desired mode of operation
TTL
1/1
M
• Press the
EV
touch display and set the desired exposure
correction (e.g. +1).
+ 2 / 3
• Press the sensor button for the desired
+ 1
exposure correction value
+ 1 1 / 3
The setting is applied immediately.
166
All manuals and user guides at all-guides.com
1/1
EV
/
) . The window
M
or
.
correction
1/1
EV
/
) . The window for
EV
or
.
sensor buttons on the
+1
.
10.3 Testing remote flash mode
• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 to set up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF measuring
beam
will blink.
• Press the manual firing button on the
master flash unit to fire a test flash.
The slave flash units will respond in
succession, according to slave group, with
a test flash. If a slave unit fails to fire a test
flash, check the settings for remote chan-
nel and slave group. Correct the position of
the slave flash unit so that it is able to
receive light from the master flash unit via
the sensor
.
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation
of the modelling light also activates the
modelling light of slave flash units.