Setting the mode of operation
• Switch on the flash unit with the
ETTL
0.8- 9.0 m
M-
5,6
35
m
F
Zoom
m
EV
• Press the sensor button of the displayed
ETTL
0.8- 9.0 m
M-
5,6
35
m
Zoom
F
m
EV
k
MODE
O
• Press the
A
M
• Press the
STROBO
p
q
M
• Set a suitable mode of operation on the
9.0 m
• Tap the shutter release to transfer data bet-
M-
5,6
35
m
Zoom
F
m
P
1/1
174
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
mode of operation that was used last .
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
M
touch display and select
.
M
sensor button on the touch
display.
M
camera, e.g.
.
ween the flash unit and the camera.
+
Various cameras support manual flash mode
M only in the camera's M mode (manual).
In other camera models, an error message
appears in the display and the release is
M
locked.
Manual partial light output levels
9.0 m
Partial light output can be set in manual flash
M
mode
M-
5,6
35
m
F
Zoom
m
Setting procedure
P
• Press the sensor button for partial light out-
1/1
put on the touch display as many times as
P
O
it takes for the partial light output display
to appear.
1/1
• Press sensor buttons
1/1 - 1/3
touch display and set the desired partial
light output to 1/1, 1/2, 1/8 . . . 1/256.
p
q
P
O
• Press the sensor button on the touch
display for the selected partial light output.
1/4 - 2/3
1/8
1/8 - 1/3
p
q
The setting is immediately effective and
automatically saved.
M
The distance display is adjusted to the partial
light output automatically (see 5.2).
3.1 m
M-
35
m
Zoom
m
P
1/8
.
on the