Setting The Slave Group; Testing Remote Flash Mode - Metz mecablitz 52 AF-1 Nikon digital Mode D'emploi

10.2.3 Setting the slave group

REMOTE
CH • Press the sensor button on the touch
A
SLAVE
2
display for the channel group (e.g
The window for selecting the channel and
Z
35 mm
OOM
group appears.
INFO
• Press the sensor button on the touch
CH
display for the group "GROUP".
2
GROUP
A
• Press the sensor button on the touch
GROUP
display for the desired group "A", "B"
A
or "C".
B
The setting will take effect immediately.
C
A I CH2
).

10.3 Testing remote flash mode

• Place the slave flash units in the desired
positions for the shot. Use flash unit moun-
ting foot S60 (optional accessories, see 18)
to set up the slave flash unit.
• Wait for all of the flash units involved to
become flash ready. Once the slave flash
units are flash ready, the AF measuring
beam will blink.
• Press the manual firing button on the
master flash unit to fire a test flash.
The slave flash units will respond in succes-
sion, according to slave group, with a test
flash. If a slave unit fails to fire a test flash,
check the settings for remote channel and
slave group. Correct the position of the
slave flash unit so that it is able to receive
light from the master flash unit via the
sensor .
The flash mode is transmitted automatically
by master.
When the flash unit functions as master in
the cordless remote system, the activation of
the modelling light also activates the model-
ling light of slave flash units.
k
167