Health And Safety - Altrad Belle VIBRATECH 38 Manuel De L'opérateur

Before operation
Intended use:
The Poker must only be used for the intended purpose, which means for the compression of concrete of various
consistencies. Any other type of use is not in accordance with the intended use and is therefore the sole responsibility of the
respective company.
over load.
Another protection for the frequency inverter is the short circuit immunity.
EMC is an important criterion and therefore we use an aluminium chassis as protective umbrella as the best protection against
interference immunity and interference emissions.
For your own safety, as protection for others, and to avoid damage to the motor, read carefully the following usage
recommendations.
For the safe and proper operation of the ''Vibratech'', make sure that operators have been instructed in the correct use of this
machine.
Before connecting the motor to the electrical system, make sure that the voltage and frequency match with the ones stated on
the machine serial plate.
ENSURE that all housing screws are tight before starting work.
AVOID
DO NOT OPERATE the motor when this is working and without transmission.
DO NOT WORK poker in bad conditions, the motor overheats.
DO NOT WORK with the cast housing broken.
DO NOT PERMIT untrained personnel to operate the motor or connections.
MAINTAIN free ventilation of air.
KEEP the Poker in a clean and dry area.
MAKE SURE that the electrical cable is with the proper section and functioning properly.
BEFORE DOING any type of repair, DISCONNECT the Poker from the electrical system.
WHEN FINISHING the job or when taking a break, the operator should unplug, disconnect it from the electrical system, and have it
placed in such a way that it should not fall or tip.
Pokers with an integrated converter must only be connected to the voltage and frequency indicated on the power rating plate.
Rating plates can be found on the outside and inside of the inverter chassis.
The machine must only be operated when all protective devices are in place.
The use of Vibratech Pokers is not permitted in an environment where there is a danger of explosions.
Ensure that all parts of the machine are bolted and secured before operating.
In addition, all local regulations should be respected.
Vibration
PPE (Personal Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear. Wear clothing suitable for the work you are doing. Always protect skin from contact with concrete. Suitable ear defenders
Should be used.
Measure to ensure the EMC
measures in the Operators Manual are observed.
Grounding and Potential Equalisation
The correct and proper grounding assures the protection of people from dangerous voltage points (entry, exit, and intermediate circuit
Filtering
Shielding
increases the interference immunity. The consistent use of metallic chassis is one of the most important measures to assure EMC.
Linking into motor conductors.
The inductive input-coupling in an electric circuit can be reduced considerably by using twisted conductors. Capacitive, inductive and
electromagnetic input-couplings must be reduced by using shields for the cables. Only such shields used on both sides will reduce the
inductive and high frequency electromagnetic input-coupling.
General Safety

Health and Safety

9
GB
GB