Intended Use - DT SWISS RIMS Manuel D'utilisation

DANGER
Risk of damaging the wheel by selecting incorrect components or tools!
• Do not use metal tire levers. These can damage the surface of the rim, tire, or inner tube.
• Use only valves with a suitable diameter and of an adequate length. The valve hole must not be
modified.
• The maximum tire pressure of the wheel and of the tire used must not be exceeded.
• Only use rim tape, inner tubes and tires which fit the dimensions of the wheel.

2.1 INTENDED USE

The intended use for DT Swiss products is classified in five categories from riding on paved roads to
downhill and freeride riding (for details, see attached classification or www.dtswiss.com).
Only use DT Swiss products within their intended category (or lower). Otherwise the user shall assume
full responsibility.
The choice of the remaining components (hub, spokes, nipples, washer) as well as the spoking pattern
and the wheel building influence the intended use of the entire wheel and can significantly restrict it.
DT Swiss therefore recommends that the choice of the components and assembly of the wheel is
performed by a specialist.
Rims - User Manual V2020.01
9