Key Programming; Programming The Key Button - Comelit 1454 Manuel D'utilisation

Key programming

Programming the key button

} Click
to access the "SETTINGS" menu.
} Click
to access Key programming.
2
The fi rst time you access the address confi guration, key programming and call confi guration areas, you will be
asked to enter a password: the default password is 0000 (to set a new password, see page 31 for instructions).
} Enter the password and click
} Click
to display the confi gurations without the possibility of modifying them.
} Click
to access Key button confi guration.
} Select either "Key" or "I/O Actuator".
The software sets the "Key function" confi gured for default "during call" activation of the
relay corresponding to the external unit used by the interlocutor.
R
Key:
Activates the relays on board the external units.
The Key function works in two separate ways, "during call" or "outside call". The button can
be made to control up to 2 relays at the same time.
Program key function
1. Select "Prog. during call" / "Prog. outside call" to choose the settings for each
2. Select "Activate" to enable the process.
3. Select the number of the relay you want to activate.
4. Select from which external unit option you wish to activate the relay:
to access set/modify confi gurations.
status.
Relay 2 can be used only: if the external unit is iKall, if the external unit
is fi tted with a residential module Art. 3327 or an actuator module 1452.
Interlocutor: If this option is selected, the relay for the external unit with which
the call is taking place will be activated.
Door: If this option is selected, you will then have to indicate the ViP address of
the external unit with the relay you wish to activate.
1
3
4
33