Key Programming; Programming The Key Button - Comelit 1454 Manuel D'utilisation

Key programming

Programming the key button

` Click to access the "SETTINGS" menu.
` Click to access Key programming.
2
The first time you access the address configuration, key programming and call configuration areas, you will
be asked to enter a password: the default password is 0000 (to set a new password, see page 33 for
instructions).
` Enter the password and click
` Click to display the configurations without the possibility of modifying them.
` Click to access Key button configuration.
` Select either "Key" or "I/O Actuator".
The software sets the "Key function" configured for default "during call" activation of the
relay corresponding to the external unit used by the interlocutor.

Key:
Activates the relays on board the external units.
The Key function works in two separate ways, "during call" or "outside call". The button
can be made to control up to 2 relays at the same time.
Program key function
1. Select "Prog. during call" / "Prog. outside call" to choose the settings for each
2. Select "Activate" to enable the process.
3. Select the number of the relay you want to activate.
4. Select from which external unit option you wish to activate the relay:
to access set/modify configurations.
status.
Relay 2 can be used only: if the external unit is iKall, if the external unit
is fitted with a residential module Art. 3327 or an actuator module 1433.
Interlocutor: If this option is selected, the relay for the external unit with which
the call is taking place will be activated.
Door: If this option is selected, you will then have to indicate the ViP address
of the external unit with the relay you wish to activate.
1
3
4
35