Programming; Operating Test; User Training; Connecting Additional Devices - SOMFY Dexxo Compact RTS Manuel D'installation

EN

4 - PROGRAMMING

4.1 Description of the programming buttons
Buttons Function
- Triggers auto-programming
-
-
-
- Selecting a setting
I n d i c a t o r -
light A
I n d i c a t o r -
light B -
4.2 Auto-programming - Fig. 15
[1].
direction.
[2].
[3].
interrupted if any of the buttons is pressed.
It is possible to access auto-programming mode at any moment including when
the auto-programming cycle has already been completed.
Note: The remote controls supplied in the kit have already been
memorised.
At the end of installation, it is essential to check that the obstacle
detection complies with appendix A of standard EN 12 453.
4.3 Locking access to the parameters (button A) - Fig.
16
Once installation is complete, the parameters menu must always be
locked to ensure the safety of users.
Failure to follow this instruction may result in serious injury, e.g. due to
crushing by the gate.
At this stage of the installation, the Dexxo Compact RTS drive is
ready to operate.
5
off
WARNING
WARNING

5 - OPERATING TEST

5.1 Using the remote controls - Fig. 17
5.2 Obstacle detection operation - Fig. 18 and 19
(Fig. 19).
5.3 Integrated lighting operation
the lighting to be lit constantly which may result in the light being switched off
automatically due to thermal protection.

5.4 User training

6 - CONNECTING ADDITIONAL DEVICES

6.1 Description of the different additional devices -
Fig. 20
No. Description
Battery
6.2 Electrical connection of the additional devices-
Fig. 20 to 23
Switch off the electrical supply to the motor before performing any operation on
the additional devices.
General electrical diagram (Fig. 20)
Photoelectric cells (Fig. 21)
Solar kit (Fig. 22)
Wired code keypad (Fig. 23)
DEXXO COMPACT RTS
(Fig. 18).
©
Copyright 2015 SOMFY ACTIVITES SA. All rights reserved.