Before Initial Use; Assembly - Cleanmaxx 00519 Mode D'emploi

EN

Before Initial Use

PLEASE NOTE!
■ Never remove the rating plate and any possible warnings!
Before using the device, remove all packaging materials and any labels that may be on
the device and are used for protection during transportation or for advertising.

Assembly

Presser for blouses and shirts
1. Plug the telescopic rod (2) into the recess on the top of the motor unit (5).
2. Place the hanger (1) onto the telescopic rod. When you do this, make sure that the
slight bend in the hanger points forwards. The hanger must be heard to engage on
the telescopic rod.
The drip protection (3) must be located directly above the fan (4). It prevents any
water that may drip down from being able to get into the fan.
3. Attach the nylon balloon:
– Pull it over the hanger. When you do this, make sure that the side with the hole line
points forwards.
– Pull the small elastic cord at the top over the collar section (10) on the hanger.
– Pull the large elastic cord at the bottom over the mounting fl ange (8).
The device is disassembled in the reverse order.
Presser for trousers
18
1. Insert the rod with the drip protection into the recess which
is provided for it on the main device.
2. Fit the Y tube (11) on the rod with the drip protection.
3. Insert the two rods (13) into the Y tube.
4. Attach the nylon balloon (12):
– draw it over the two
– draw the elastic over the mounting fl ange on the main
device.
The device is disassembled in the reverse order.
rods.