Cleanmaxx 00519 Mode D'emploi page 20

EN
6. Turn the timer (7) clockwise and set it to the length of time you want. Each LED light
represents 5 minutes.
7. Once the nylon balloon has infl ated, straighten out the garment and smooth it down
again.
8. When the set time elapses, the device switches off automatically. The drying / press-
ing process can be interrupted at any time by turning the timer to the starting position.
9. Remove the garment from the nylon balloon and hanger (1).
10. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Presser for trousers
2. Pull the garment which is to be pressed over the nylon balloon and do up the zip or
buttons if necessary. Make sure that
– the legs of the nylon balloon fi t properly into the legs of the trousers and are not
twisted or scrunched up,
– all buttons on the garment (including the legs) are done up.
3. Spread the clamps along the bottom of the garment (at the front and back in each
case on the outsides) so that it is weighed down and will not go out of shape when
the nylon balloon is infl ated.
4. Insert the mains plug into an easily accessible socket.
5. Turn the timer (7) clockwise and set it to the length of time you want. Each LED light
represents 5 minutes.
6. Once the nylon balloon has infl ated, straighten out the garment and smooth it down
again.
7. Remove the garment from the nylon balloon after the completion of the drying/press-
ing process.
8. Pull the mains plug out of the plug socket and allow the device to cool down completely.
Tips
• The device is intended primarily for machine-spun laundry! If hand-washed or non-
machine-spun laundry is to be pressed, fi rst allow it to dry out a little fi rst.
• The drying / pressing process takes around 10 minutes for a spun-dried shirt or
trousers. However, the length of time can vary depending on the material and thick-
ness of the material. We recommend that you start with a shorter time and extend it
if necessary.
• The nylon balloon for blouses and shirts can be enlarged or reduced in size with
the aid of the zip fasteners. For smaller sizes, the zip fasteners should be closed. For
larger sizes, the zip fasteners should be opened on both sides.
20
1. If you have not yet done so, attach the nylon balloon (2)
(see the "Assembly" chapter).
The nylon balloon should sit immediately below the
mounting fl ange so that it can fully infl ate.