Safety Regulations For Finecoat Spraying - WAGNER FineCoat 8800 Mode D'emploi

Safety Regulations for FineCoat Spraying

All local regulations in force must be observed.
In order to ensure safe operation of the FineCoat systems
the safety regulations listed below must be followed.
1. Read the operating manual carefully and follow
theinstructions given in order to avoid possible
danger.
2. Only coating materials with a flash point of 21 °Cor
over may be sprayed, without additionalheating.
3. Use of this unit is prohibited in workshops whichcome
under explosion prevention ordinances.
4. Never operate near sources of ignition, e.g.,
openflames, cigarettes, cigars and pipes, sparks,
redhotwires, hot surfaces, etc.
5. Warning! Risk of injury by injection!
Never point the spray gun at persons or animals
Danger
For breaks in work always secure the spray gun
against unintentional operation (see page 19, fig. 11).
GB
6. Always wear a protective mask when spraying. In
order to avoid occupational illnesses, always follow the
manufacturer's instructions for the materials, solvents and
cleaning agents used when preparing and using such
materials and when cleaning the unit. Protective clothing,
gloves and, if necessary, skin protection cream should be
used to protect the skin.
7. For safety reasons, never use solvents based on 1,1,1
trichloroethane or methylene chloride.
8. Caution: When operating the FineCoat system indoors
or outdoors, make sure that no solvent vapors are
carried towards the turbo-blower and that no solvent
containing vapors can accumulate in the near the
turbo-blower.
Position the turbo-blower on the opposite side to the
object to be sprayed. Check the wind direction when
spraying outdoors. When working indoors, a sufficient
flow of air must be ensured for extracting the solvent
vapors.
A minimum distance of 3 m must be maintained
between the turbo-blower and the object being
sprayed.
9. Extraction systems should be installed on-site in
accordance with local regulations.
10. The work-pieces to be sprayed must be earthed.
11. When cleaning the unit with solvents, never spray into a
container with only a small opening (bunghole). Formation
of a explosive gas/air mixture. The container must be
earthed.
12. When transporting the system, it must be suitably secured
for the particular means of transport.
13. Always remove the mains plug from the socket before
carrying out any work on electrical components.
14. Work or repairs to the electrical fittings must be carried out
by a specialist electrician. This is also valid even if there
are references to such work in the operating manual. No
liability will be accepted for improper installation.
15